Additions for V8 engine cooler

These are some additions for the V8 engine cooler: https://www.thingiverse.com/thing:6015816

There is a cover for the ice compartments. I drilled holes in the block and the cover itself to add small magnets but this is not required.

There are two different types of arms that attach to the engine block - one angled and one more blocky. They may require a bit of fiddling but mine connected ok. I superglued them in and have had no problem so far. There is a 3/8" hole at the top of each of these to facilitate a section of 3/8" threaded rod. This is held in place by 3/8" nuts and washers with acorn nuts on the end.

The threaded rod was not the most comfortable to grab and hold on to so I altered thehan's bucket handle (https://www.thingiverse.com/thing:2177302) to make a carrying handle for the rod. This was also held in place with 3/8 nuts and washers. Sorry the photo does not show this.

Thanks for the awesome designs. I have also merged the two sides of the engine plate and d