Thingiverse
Adhesive PCB mount M3 captive nut
von scottbez1
11
Downloads
7
Likes
0
Makes
A simple M3 standoff mount that can be attached to any surface with 1/2" foam adhesive tape (e.g. VHB). Uses a captive standard M3 nut for a reusable threaded mount. 5mm tall (not including foam tape).
Prints very quickly and without supports so there is zero post-printing cleanup needed. Just drop in a nut, attach a square of adhesive tape, and stick it wherever!
This is an alternative to common HC-5 nylon adhesive PCB mounts, which tend to have very stiff latches so the PCB is hard to remove once attached.
Extra items needed:
- M3 bolt (for a 1.6mm PCB: 6mm length)
- M3 hex nut
- 1/2" foam double-sided adhesive tape (e.g. VHB)
I've also included the Fusion 360 design file if you'd like to modify or customize the design.
Prints very quickly and without supports so there is zero post-printing cleanup needed. Just drop in a nut, attach a square of adhesive tape, and stick it wherever!
This is an alternative to common HC-5 nylon adhesive PCB mounts, which tend to have very stiff latches so the PCB is hard to remove once attached.
Extra items needed:
- M3 bolt (for a 1.6mm PCB: 6mm length)
- M3 hex nut
- 1/2" foam double-sided adhesive tape (e.g. VHB)
I've also included the Fusion 360 design file if you'd like to modify or customize the design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
