ADIMLab E3D V6 Adapter

Adapter to use an E3D V6 with the stock extruder

Updated 9/26/2019: I've added a second version that holds the V6 in place much better than the original. Uses all of the same hardware as the original except v2 no longer requires the M3 x 20 screw and nut to tighten.

Place the M4 nuts into their slots on the female piece (see image 2). Place the V6 into its slot on the male piece (image 3). Press the male and female pieces together (image 5). Make sure they are pressed together very tight (no gaps, if this proves difficult you might want to use a vice or something similar to squeeze together). Use the M3 x 25 screws to attach to the extruder motor and hold pieces together.