Thingiverse
Adimlab Gantry Z Stepper Bracket
por jonbourg
1
Descargas
3
Likes
0
Makes
An additional mount for the Z motors on the Adimlab Gantry printer.
Hardware:
2 M3 x 12 screws for the motor
2 M4 x 8 screws to mount on the 2020 extrusion
2 M4 t-nuts
Install
Put M3 screws in
Put on motor and start M3 screws
Push t-nuts into the extrusion and align with hole
Carefully install M4 screw and get started in t-nut
Tighten all screws, but be careful not to overtighten
Hardware:
2 M3 x 12 screws for the motor
2 M4 x 8 screws to mount on the 2020 extrusion
2 M4 t-nuts
Install
Put M3 screws in
Put on motor and start M3 screws
Push t-nuts into the extrusion and align with hole
Carefully install M4 screw and get started in t-nut
Tighten all screws, but be careful not to overtighten
jonbourg también publica en
5 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!