ADIMLab Undercarriage

My first 3d Printer was an ADIMLab Gantry-S. One of the stepper controllers on the original motherboard failed, so I bought a BIGTREETECH SKR V1.4 Turbo motherboard and a BIGTREETECH TFT35 E3 screen to replace it and the original screen. I wanted to move the electronics under the chassis, so I designed this.


- The chassis for the ADIMLab Gantry-S is approx. 37mm deep by 34mm wide. This should fit other printers of the same size, with 20x20 or 20x40 rails.
- The stock feet can be used in this undercarriage. I used the locking nuts to secure them in.
- you will need alot of tnuts and screws to attach it to the printer chassis
- You will need alot of 3mm screws and 3mm burled heat pressed nuts to connect the sections and covers.
- I have not tested the drawer_case or the drawers yet. I included a small corner (drawless_case) to use in its place (like you see in my pictures). You can replace any of the 4 sections with it (mirror it for other corners).
- This moves the motherboard