Adjustable 40mm Fan BL Touch Mount

I wanted to reclaim space on my X-Axis, so I figured a 40mm BL Touch fan mount was needed. However, after a few iterations of a static mount, I felt it pertinent to redesign it from the ground up so there was at least some level (no pun intended) of Z-Axis adjustment.

I printed with ASA, but you can use PLA.

The design was created in a way to reduce supports needed, though YMMV.

Printing:
1. Spacer isn't necessary, but I'd recommend printing it at the same time
a. due to the proximity of the BL touch, it can slightly increase hot end fan noise
b. use of spacer reduces/eliminates this noise
2. Parts have sides with curves and flat sides. Print flat sides down.


BOM:
1x M3 nut
1x M3 nylon lock nut
2x 5mm socket cap screws
1x 15 to 20mm socket cap screw for carriage adjustment
4x 15mm socket cap screws for mounting through frame and fan

Assembly:
1. Press M3 nut into carriage. Bottom of the nut retainer hole is formed to shape of nut (i.e. pointy side