Adjustable Airplane Phone Holder

A simple phone holder that attaches to the tray table of an airplane seat. Which features an adjustable and locking angle and height. Fully 3D printed, no other parts are required.No supports needed Assembly InstructionsAlign the teeth of the phone clamp and the table clamp as shownInsert the screw through the gears in both clamps and tighten until snug. The first time you do this, there might be a bit of resistance.Align the top L bracket of the phone clamp (extendable section) as shown and insert it into the gap.The first time you do this, you&#39;ll need to “snap” the ratcheting mechanism with some pressure. Align and insert the locking pin as shown Adjusting angle and heightTo adjust the angle, loosen the screw by about a half-turn. Rotate the phone clamp to your desired angle and re-tighten the screw. To adjust the height, pull up on the locking pin; move the extendable section up or down; then push back down on the locking pin until it clicks. <img src="https