Adjustable Can Dispenser (separate dowel version)

Original version has built in connector dowels which require supports and do not fit well.
This version has separate dowels for easier print and assembly.
Uses threaded connectors to allow adjustment to different can heights.
Should work with ~110mm to ~160mm tall cans.

This version is split for printing on smaller bed (200mm x 200mm).
Print 4 main pieces, 4 large dowels, 4 small dowels and 4 threaded connectors.
You may or may not need a brim for connectors depending on your bed adhesion.
To assemble, use dowels to glue front and back of each half together. Screw connectors into both dispenser halves simultaneously. Be sure connector is oriented correctly (threads are reversed for each half).

If connectors are too snug or loose, you can scale the x and y slightly to compensate but be sure NOT to scale in z direction so thread pitch does not change. I suggest printing a test connector (or partial) first to check fit.

See original design for more notes:
https://www.thing