Adjustable Center Hub Spool Holder

This is a quick change spool holder. I didn't want to have to unbolt the spool every time I changed out some filament. I also tried a spool holder that sits on top of bearings, but when you got close to the end of the filament, the spool would get pulled off of the holder.

This is a remix of three things with a bit of my own design. The arms hold the hubs on a track system and when you turn the knob it tightens up to hold the filament spool in place. A dab or two of super glue secures the knob to the screw. The hubs are designed to spin on 608 bearings with 8mm x 60mm long bolts for attachment. You will need 4 each bearings, 2 each bolts with nylock nuts and 6 each 8mm washers. Tighten the nylock nuts to where the hubs will spin freely.

The hubs will accommodate spools with a center hole of 50mm - 65mm. If you have a larger spool also print 2 of the "enbiggener" parts. This expansion sleeve slides over the original hubs - increasing the capacity up to 85mm. I have re