Thingiverse
Adjustable Circuit Board Holder Span
door brawfx
8
Downloads
8
Likes
0
Makes
I purchased a PCB holder and it had a max width of 9". That was too short for a project I'm working on, so I made this modular span replacement.
The pieces are 30mm x 15mm x 120mm with an additional 10mm for the plug ends. There is only mechanical friction holding them together, so I would suggest cyanoacrylate glue or epoxy once you have the length you need.
The board I have is about 11", so I printed one male end cap, one female end cap and two spans.
Holder: https://www.amazon.com/gp/product/B01709B0PW
The pieces are 30mm x 15mm x 120mm with an additional 10mm for the plug ends. There is only mechanical friction holding them together, so I would suggest cyanoacrylate glue or epoxy once you have the length you need.
The board I have is about 11", so I printed one male end cap, one female end cap and two spans.
Holder: https://www.amazon.com/gp/product/B01709B0PW
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
