Thingiverse

Adjustable filament spool holder

von valtte

18 Downloads

30 Likes

1 Makes

I made this filament spool holder to improve printing speed and to prevent extruder clicking.

The design works with any spool that is larger than 10cm (3.9 ") in diameter and less than 13cm (5.1") wide.

This spool holder uses four 608 bearings. The same bearings that are used on fidget spinners, Skateboards etc. and they are also pretty cheap.

Part list:
-4x 608 BEARING.
-4x m8x25 Countersunk Head Screw Bolt. (not necessarily can also be printed)
-4x m8 nut. (not necessarily can also be printed)

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat