Adjustable graphic card holder Nvidia

Min. height 47 mmMax height 83 mm I set print by object method because different layer heights and ironing. Main item (bulid plate 1)0,2 mm layer heightIroning on top surfaces (I set 30mm/s and 30% (I think the correct setting depends on the printer and the type of filament) Inner rod (build plate 2)0,12 mm layer heightno ironing Boost MeBoost me if you like it! Thank you! ;) An 8x2 mm magnet can be placed in the bottom.On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole, but it's not necessarily necessary. If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better. High-speed printing is not recommended due to fine details. It probably won't work if resized. Check out my other uploads and download and print them. ROG, RTX, Aorus, AMD, TUF, and many more. !!! Make sure the print speed and temperature and cooling are set correctly for your printer and the filament you are using. And the bu