Adjustable motor mount for GO Hyper m2

I designed this 3D printed upgrade that I call Adjustable motor mount for Hyper GO m2. I designed this 3D printed component so I can adjust the gear mesh on this RC vehicle as you see in one of the photos. also I needed to remove some material off
of the Rear gear cover no.16190 as you will see in one of the photos so it will not mess up the gear mesh. after having it 3D printed out and after i have installed it and and took it outside and ran it for a test run as a result I was successful with this 3D printed upgrade. if you wish to download this file do so. after that, set your 3D printer you know the drill in regards to your own perspective 3D printers. then after that you're done. then clean it up and installing your RC vehicle and take it out for a test run. after that you're done, so enjoy.



My recommendation to have this machine in aluminum if you're able to do so. or get better plastic filament that that can with stand heat of the brush or brushless motor. better as fo