Thingiverse
Adjustable mount for (old) MPCNC DW660 - Fix perpendicular alignment problems
door cmidgley
57
Downloads
42
Likes
0
Makes
> NOTE: This is for the old version of the MPCNC. I have not yet built the new one, but Allted says it no longer needs alignment (see the [comments](http://www.thingiverse.com/thing:1355544/#comments) tab for his thoughts).
- - -
> Updated 12/8/2016: Added the outer rings for the upper and lower mounts. Before you could get these from Allted's mount, but he has changed them for the new 525 MPCNC so I've added my own models for people who need them on the legacy MPCNC
This is a remix of Allted's DW660 mount for the Mostly Printed CNC. I was compelled to make it when I faced a board and had "zebra stripes" across my surface because my DW660 wasn't perfectly perpendicular (facing with 1/2 or 3/4 requires fairly precise alignment; see before/after picture above). I didn't like adding shims since it was difficult to get accurate and consistent alignment, especially on tool changes.
I decided to add adjustment screws into the design. You use the lower adjustment screws to
- - -
> Updated 12/8/2016: Added the outer rings for the upper and lower mounts. Before you could get these from Allted's mount, but he has changed them for the new 525 MPCNC so I've added my own models for people who need them on the legacy MPCNC
This is a remix of Allted's DW660 mount for the Mostly Printed CNC. I was compelled to make it when I faced a board and had "zebra stripes" across my surface because my DW660 wasn't perfectly perpendicular (facing with 1/2 or 3/4 requires fairly precise alignment; see before/after picture above). I didn't like adding shims since it was difficult to get accurate and consistent alignment, especially on tool changes.
I decided to add adjustment screws into the design. You use the lower adjustment screws to
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
