Thingiverse
Adjustable Phone Holder
von onratak
54
Downloads
42
Likes
0
Makes
The same material is required for long and regular models. If your phone is 5 inches or larger, you can use the long model. The difference between the two models is that the lower platform of the long model is longer and the center of gravity is adjusted accordingly.
The prints were bad because of the problem with the filament.
The following parts are required:
1x 25mm or longer screw
1x Nut
You can watch the video for installation or use.
The prints were bad because of the problem with the filament.
The following parts are required:
1x 25mm or longer screw
1x Nut
You can watch the video for installation or use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!