MakerWorld
Other House Models
Go to Model
Adjustable Picture Hanger
41
Downloads
9
Likes
41
Makes
Simple wall hanger for canvases. Mounts on a single nail or screw and allows small left/right adjustment for easy centering. Includes a center notch to help position it during installation. Uses less than 6 g of filament. Recommended Print Settings Layer height: 0.28 mm Infill: 100% No supports needed Hardware Used 2 self-tapping screws 3 × 15 mm Installation Find the center of your canvas/frame. Use the center notch to align the hanger. Mark the screw positions. Pre-drill small holes in the wood frame using a hand pin vise or small drill. Attach the hanger with two 3 × 15 mm screws. Place the wall nail into the desired tooth slot. Slide left or right until perfectly centered. Notes Best used with lightweight to medium-weight canvases. Pre-drilling helps avoid splitting the wood. For maximum stability, add small rubber pads to the bottom corners of the frame.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
