Thingiverse
Adjustable Pistol Brace
von saridnour
1
Downloads
4
Likes
0
Makes
Remix of PrinterGoBurrr Adjustable Pistol Brace.
Made a few changes to the core PISTOL_BRACE.stl.
1- narrowed the diameter of the buffer tube shaft for a closer fit. Please make sure your printer is calibrated as this is near mil spec in design (reduce most if not all wobble while stil moving free if printer is calibrated correctly).
2- removed the triangular sub section of the tube shaft as will form fit the buffer tube better again aiding in a better less wobble fit.
3- took the angle off the rear of the butt plate so would print flat with no need of support for the rear end thus looking cleaner.
4- skeletonized the tub a bit more opening up the holes just to give it a little more see through for colored tubes. With the more form fit tube shaft this will not effect fit/wobble.
All other parts are the same at this point so please pull them from the original here: https://www.thingiverse.com/thing:5022192/files
Made a few changes to the core PISTOL_BRACE.stl.
1- narrowed the diameter of the buffer tube shaft for a closer fit. Please make sure your printer is calibrated as this is near mil spec in design (reduce most if not all wobble while stil moving free if printer is calibrated correctly).
2- removed the triangular sub section of the tube shaft as will form fit the buffer tube better again aiding in a better less wobble fit.
3- took the angle off the rear of the butt plate so would print flat with no need of support for the rear end thus looking cleaner.
4- skeletonized the tub a bit more opening up the holes just to give it a little more see through for colored tubes. With the more form fit tube shaft this will not effect fit/wobble.
All other parts are the same at this point so please pull them from the original here: https://www.thingiverse.com/thing:5022192/files
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
