Adjustable Sliding Door Guide

Adjustable door guide for sliding closet doors. Modeled after the worn out original I replaced in every room of my home.

To print:

I used PLA, which works fine, but PETG would be a bit stronger and more resilient.
Supports are needed for the inner guide.
Print one inner and two outer pieces.

To install:

• Remove the old guide
• Remove the front (outer) door
• Slide the back (inner) door to one side
• Position the inner guide so the tall piece is just a little in front of the door, and the edge of the door is just past center of the guide
• Screw the inner guide in place
• Insert the outer guide under the back edge of the inner guide and position just a little behind the door. Screw in place
• Hang the front (outer) door back in place
• Insert the second outer guide under the front edge of the inner guide and position just a little in front of the door. Screw in place