Thingiverse
Adjustable Spool Holder
von sfi25
2
Downloads
4
Likes
0
Makes
Adjustable spool holder for spools of any width and diameter (135 < d < 250).
Printed parts needed:
- pole.stl (4x)
- rod.stl (2x)
Needed for assembly:
- 608 bearings (4x)
- 8mm linear smooth rods (2x, any length, approx. 150mm is good)
For best results, mount with clips facing outside.
Printed parts needed:
- pole.stl (4x)
- rod.stl (2x)
Needed for assembly:
- 608 bearings (4x)
- 8mm linear smooth rods (2x, any length, approx. 150mm is good)
For best results, mount with clips facing outside.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
