Admech inspired lantern

### About this project
This project started based on my [Admech inspired incense burner](https://www.reddit.com/r/AdeptusMechanicus/comments/1dwkmia/adeptus_mechanicus_incense_burner/)
I got some requests to publish the files, but I didn't feel comfortable with that because I didn't take the time to use easily available parts and optimize the files.
Instead i decided to design a new and smaller version to make this awesome piece of decoration more accessible to everyone (with a printer).

The Lamp is designed to hold an LED tealight as shown in the picture.
DO NOT USE AN ACTUAL CANDLE WITH THIS!
The hole in the "roof" section is meant to be used with an m6 bolt, but you could probably feed a wire through here to power a stronger LED light source.
You will have to be cautious about heat generation here though.

### Materials
To build this you will need to 3d print the following parts:
- 1x bottom
- 1x ring
- 1x roof
- 6x side
The parts print support free except for the "