Thingiverse
Electronics
Go to Model
ADS-B Cantenna
71
Downloads
44
Likes
0
Makes
Window mount and jigs for building an ADS-B 1090MHz Cantenna for use with [PiAware](https://flightaware.com/adsb/) and other ADS-B receivers.
I included printable jigs to find the can center and to cut the can and vertical element to the proper length.
This model is designed for 68.75mm (1090MHz quarter wavelength) elements. This can be adjusted slightly by scaling only the horizontal axis.
Inspired by the following cantenna articles:
[FlightAware Forum Post](https://discussions.flightaware.com/t/three-easy-diy-antennas-for-beginners/16348/3), by abcd5670
[Hackaday Article](https://hackaday.com/2018/01/23/an-ads-b-antenna-built-from-actual-garbage/), by Tom Nardi
I included printable jigs to find the can center and to cut the can and vertical element to the proper length.
This model is designed for 68.75mm (1090MHz quarter wavelength) elements. This can be adjusted slightly by scaling only the horizontal axis.
Inspired by the following cantenna articles:
[FlightAware Forum Post](https://discussions.flightaware.com/t/three-easy-diy-antennas-for-beginners/16348/3), by abcd5670
[Hackaday Article](https://hackaday.com/2018/01/23/an-ads-b-antenna-built-from-actual-garbage/), by Tom Nardi
ewsandor also publishes on
9 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
