Thingiverse
ADSM302 Microphone Arm Mount
di Chrismettal
21
Download
16
Likes
1
Makes
Microphone arm mount for ADSM302 or similar microscopes with up to 35mm in mount diameter.
You will need:
3 x M3 square nuts
3 x M3x10 or similar screws
1 x M3x40 mm or similar screw
These parts should be familiar to Prusa owners and will still be in the spare bag.
Drop in the 3 nuts into the slots from above and screw in the short screws to hold your scope.
The longer M3x40mm screw goes through the longer arm piece from the inside. Just screw it as far as it will go. This will act as a stiffener for the arm and will prevent you ripping your holder off when you move the microphone stand by the scope itself.
The arm shown here is a cheap Tonor T20.
---
>If you need one of my things printed or you want to suggest a modification on a part please drop me a message!
>
>If you print one of my things i would be happy about some feedback and a make!
---
If you like my things please consider supporting my caffeine addiction!
You will need:
3 x M3 square nuts
3 x M3x10 or similar screws
1 x M3x40 mm or similar screw
These parts should be familiar to Prusa owners and will still be in the spare bag.
Drop in the 3 nuts into the slots from above and screw in the short screws to hold your scope.
The longer M3x40mm screw goes through the longer arm piece from the inside. Just screw it as far as it will go. This will act as a stiffener for the arm and will prevent you ripping your holder off when you move the microphone stand by the scope itself.
The arm shown here is a cheap Tonor T20.
---
>If you need one of my things printed or you want to suggest a modification on a part please drop me a message!
>
>If you print one of my things i would be happy about some feedback and a make!
---
If you like my things please consider supporting my caffeine addiction!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
