Advent calendar Tree

Quick design and there is still time to print, not the cleanest finish but lots of space for a lot of candy (or whatever). And go nuts with colored filament, I just had nothing fancy around.

The drawers stay in by friction alone, depending on print tolerance they might be a bit too loose. If thats an issue either scale a tiny bit the height of the drawers or use a slim piece of tape at the drawer underside for a quick fix. One could also lock each drawer with a tiny bit of filament from a 3d print pen, which has to be snapped off for opening.

Assembly should be simple enough, but wait with the glue until all is put together ... depending on rotation of each stage the tree can look quiet odd. Try rotate the stages until its ok and make sure the stage on top lines up with the corners of the drawers so that each is closed fully.
Like a real Christmans tree it will have its good and bad side, so dont glue the stand so that it can rotate back to the good side after getting the daily loot