Thingiverse
ADVENT Speaker Wall Mount
door agf_Ender3
6
Downloads
3
Likes
0
Makes
Designed this mount for my RV to be able to mount bookshelf speakers on the outside wall and be able to remove them when not used.
Holes on Speaker Mount are 60mm center to center. 5mm diameter.
Mount overall is 75mm x 75mm
Post is 13mm, Hole is 13.5mm
Wall side printed on end, no supports.
Speaker Side Mount printed with post upright and supports on build plate only.
Printed with 6 walls and 6 layers top and bottom.
Infill 40% Gyroid
Layer Height .28
Holes on Speaker Mount are 60mm center to center. 5mm diameter.
Mount overall is 75mm x 75mm
Post is 13mm, Hole is 13.5mm
Wall side printed on end, no supports.
Speaker Side Mount printed with post upright and supports on build plate only.
Printed with 6 walls and 6 layers top and bottom.
Infill 40% Gyroid
Layer Height .28
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!