Adventurer 5m Stealthburner

This mount is to put a Voron Stealthburner on the Adventurer 5m. The load cell type leveling sensors are under the bed so no probe is necessary. The Stealthburner also shares the NEMA 14 pancake extruder motor and 5015 blower fan that the Adventurer 5m uses.

Materials:
6 m3 x 6 screws (reuse the 4 holding the stock print head on)
2 m3 x 25 screws
2 m3 x 50 screws
Stealthburner

Instructions
Install m3 threaded inserts in all holes on 3d print
Install Stealthburner on print as if it were a Voron x carriage (refer to Stealthurner assembly manual)
Install on Adventurer 5m x carriage using 4 m3 x 8 screws

Notes
The nozzle will be about 8mm lower. MEASURE THIS AND FIX IN FIRMWARE!
Stock part cooling fan can be reused
For best results define new nozzle offset in firmware

Disclaimer:

This is a DIY project and requires a good understanding of 3D printing, electronics, and Klipper firmware. Always exercise caution when working with electrical components and moving machinery. Modifications t