ADXL345 MK6 Mount

Designed to mount an ADXL345 on the nozzle - DO NOT print with this in place, it is designed to be installed, resonance tested, and removed after.

Mount for using Klipper to configure your Ender 3 Pro (or other MK6 hotend printer).

The original was too thick for the nozzles I have to screw into place, so I hit up TinkerCAD and thinned the area where the nozzle goes by about half.

Here's what the author (digunderground) of the one I based it on said:
Designed to mount an ADXL345 on the nozzle - DO NOT print with this in place, it is designed to be installed, resonance tested, and removed after. This fits an adafruit ADXL345 but also has holes for smaller boards but I have not tested those as of yet.

By moving the mount to the nozzle, you should get the most accurate results relevant to the actual print surface. Additionally this should allow your to introduce less smoothing at higher accelerations - IE using MC vs MCV or 2HumpEi.

For printing, 2 perimeters/top/bott