Thingiverse
Aeroccino base
by blammnl
32
Downloads
25
Likes
4
Makes
I had a coffee machine that broke that had an attached milk frother. After opening up the bottom of the machine, I could detach the socket of the Aeroccino, which was directly powered by mains.
Modeled a base around the connector with an opening for a power cord and strain relief for it. Soldered and heatshrunk the wires together and we can enjoy our frothy cappuccinos again!
Used M3 heat inserts for the bottom screws and 2mm selftapping for the wire strain
Modeled a base around the connector with an opening for a power cord and strain relief for it. Soldered and heatshrunk the wires together and we can enjoy our frothy cappuccinos again!
Used M3 heat inserts for the bottom screws and 2mm selftapping for the wire strain
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
