Aerodynamic Flying Glider

Aerodynamic Flying Glider 12grams of Filament! 35 minute Print Time! 3 Parts! Print, assemble, and have fun! The glider prints in 3 parts consisting of the Fuselage, Main Wing, and Rear Wing. To assemble simply glue the two wings to the fuselage with superglue for the best adhesion. Ensure the connector piece found on the main wings between the two main beams running along the wing is glued to the fuselage with the rear of the connector just in front of the 2 support beam found on the fuselage. The front tip of the Wing should be about 8.25 cm from the very tip of the fuselage. This is how the Wings are supposed to be glued on! The inside channel of the rear wing may need some cleaning due to the way the overhang is printed so make sure its completely open without any weird extrusions hanging. If there are any simply clean it out with a hobby knife. I hope you Enjoy and have Fun! <bo