Thingiverse
Aerogarden Extender
von zimirken
153
Downloads
76
Likes
2
Makes
This is a height extender for an aerogarden lamp. You might run out of power cable though, but I'm sure you can find an extender.
You'll want to print it with thick walls as it will be under bending force, but not necessarily high infill.
You'll want to print it with thick walls as it will be under bending force, but not necessarily high infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!