AeroPress Filter Cap Alternative

Update 25 August:Even in the very good colorfabb filament this print failed due to poor Z axis bonding! I’m considering printing sideways with supports and annealing. Proceed carefully. Do not print in any standard filaments for use with hot water!If you want a custom hole/drip pattern, let me know :) I printed this with HT Clear from colorFabb. First day with it and I'm impressed! I tweaked the settings a lot but the final product shows zero softness or deformation from boiling temperature water (poured not submersed). I did model in almost 0.5mm diameter changes due to the tolerances I saw in this material. Filament settings that I used: 280°C nozzle100°C bed12mm mm³/s vol speed1.02 flow ratio Cooling all layers (ie, 0 layers “no cooling”)Normal Z HopSlicer settings:0.4mm for ALL line widths3 walls, 5 top shells, 5 bottom shells, 75% rectilinear sparse infillNormal supports with 2 layers of PLA for the interface10mm outer brimWorked perfectly!The filter cap won't work with ot