MakerWorld
Other House Models
Go to Model
Aerosol Spray Nozzle
924
Downloads
205
Likes
630
Makes
Here is a simple Aerosol Spray Nozzle. It will fit any can with a 4mm piped opening and has a 1.8mm spout to deliver the spray with reasonable force. Most cans show a reasonable 8-12 inches of spray. For quality, I would suggest you allow this to print slowly. For some reason, Bambu Filament at profile speeds will print too fast for the overhang and give a poor surface quality. The pre-setup profile is set for 60mm walls and that appears to help a lot. So, if you take the STEP file and use your own settings, be aware.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
