Aimpoint T1 Lens protector

This is a DIY lens protector for the aimpoint t1 and the replicas found on amazon.

Simple to make with just a few tools.

You will need:

.080 plexyglass

1 1/4 hole saw with center bit removed to cut the plexiglass.

number 30 oring

White lithium as lubricant to apply to oring and then you gently twist on the lens protector.

To assemble clean up edges of plexyglass and snap into protector. Install oring onto groove on objective end of scope. Apply a small amount of grease to oring. Then gently twist on protector.