Slicer Discord
Air pump from small angle grinder – Modelo 3D imprimible de MakerWorld MakerWorld
Sport & Outdoors

Air pump from small angle grinder

100 Descargas
87 Likes
22 Makes
Ver Modelo
💥 Donations can be made here: https://boosty.to/prosmp/donate💥All our contact information here: https://hipolink.me/prosmp YouTube channel: https://www.youtube.com/@prosmp I got tired of inflating my SUP and inflatable boat with a hand pump, so I made a pump from a small cordless Jauhi angle grinder from Aliexpress (the picture is clickable)Now it is much faster and easier to inflate the SUP. It takes around 30 seconds to inflate or to fully deflate my 3,5m long SUP. However, this is not a high-pressure pump. After the initial pumping, you need to additionally pump it with a hand pump to the required pressure. Most likely, this pump can be attached not only to the Jauhi grinder, but I have not checked (mine was the cheapest). If you want to use a different grinder, look at the photos of the cutting disc protection mount. It should look like the one on the photo: The pump looks like a small turbine that is attached to the grinder instead o
Categoría
Sport & Outdoors
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

ProSMP también publica en

79 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

3 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección