Slicer Discord
air skate board – 3D-Druckmodell von Thingiverse Thingiverse

air skate board

von pdizzy
0 Downloads
0 Likes
0 Makes
Zum Modell
We created this to use while driving. it can be held out the window and used to surf on top of the wind. the hole in the side is to tie a small string through it and around your wrist. dont make the string too long or it will rattle against the side of the car. Do not use if you are the driver. this is for passengers only! Back roads below 40mph is the best and convertibles are always fun, with or without this toy. Learn about wind resistance, balance and bruised forearms. Most importantly- have fun and be patient while you master the art of air fingerboarding. shred the gnar!!!
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen