Thingiverse
Airbox for BMS Intake
von yakboyslim
5
Downloads
7
Likes
0
Makes
UPDATED DESIGN
Much Simpler. Print the lid, base and 3 of the bushings. Mounts to the OEM posts. Attachment between the lid and base right now is by gluing three pairs of tabs onto the base and lid then connecting with o-rings. I planned to improve this, but never got to it.
This is an airbox (https://burgertuning.com/products/bms-ea888-intake) for the BMS intake for EA888 Engines If you use this please consider donating.
This replaces all the stock intake plastic, but requires a 3" duct run to it otherwise it will draw exclusively hot air from the engine bay. I designed a duct to replace the foglight (https://www.thingiverse.com/thing:6442128)
Much Simpler. Print the lid, base and 3 of the bushings. Mounts to the OEM posts. Attachment between the lid and base right now is by gluing three pairs of tabs onto the base and lid then connecting with o-rings. I planned to improve this, but never got to it.
This is an airbox (https://burgertuning.com/products/bms-ea888-intake) for the BMS intake for EA888 Engines If you use this please consider donating.
This replaces all the stock intake plastic, but requires a 3" duct run to it otherwise it will draw exclusively hot air from the engine bay. I designed a duct to replace the foglight (https://www.thingiverse.com/thing:6442128)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
