Thingiverse
Household
Zum Modell
Airbrush Holder
685
Downloads
521
Likes
4
Makes
Super easy airbrush holder to be screwed to a wooden panel or something.
IMPORTANT: HOW TO USE
===
Place the airbrush inside the holder and rotate it clock/counterclock-wise until you find the perfect balance. Each airbrush is different and requires different inclination. Usually a 20-30 degrees angle is good enough.
When you find the perfect spot, just screw the holder to the panel with two 3mm countersunk screws (head 6mm).
Printing suggestions
===
I printed mine at 0.15mm layer height with a 25% infill and 3 walls. The holder came out very sturdy and that's how I like it :) But the design is incredibly simple so you can get away with 0.2 or even 0.3mm layer height.
The model requires supports.
IMPORTANT: HOW TO USE
===
Place the airbrush inside the holder and rotate it clock/counterclock-wise until you find the perfect balance. Each airbrush is different and requires different inclination. Usually a 20-30 degrees angle is good enough.
When you find the perfect spot, just screw the holder to the panel with two 3mm countersunk screws (head 6mm).
Printing suggestions
===
I printed mine at 0.15mm layer height with a 25% infill and 3 walls. The holder came out very sturdy and that's how I like it :) But the design is incredibly simple so you can get away with 0.2 or even 0.3mm layer height.
The model requires supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
