Thingiverse
Airbrush Paint Strainer Filter
door SteveFury
120
Downloads
68
Likes
0
Makes
This is my airbrush paint strainer.
I uploaded two sizes: Large and 50% smaller. It consists of two pieces, the base and the insert. To set it up, stretch your filter material over the bottom of the insert (Thin cotton, old nylon stocking etc) and seat the insert into the base. Trim the excess filter from around the side (See photo).
The base should sit on the top of your open paint bottle or small art paint can with the 3 legs.
I uploaded two sizes: Large and 50% smaller. It consists of two pieces, the base and the insert. To set it up, stretch your filter material over the bottom of the insert (Thin cotton, old nylon stocking etc) and seat the insert into the base. Trim the excess filter from around the side (See photo).
The base should sit on the top of your open paint bottle or small art paint can with the 3 legs.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
