Thingiverse
Aircon Pipe Wall Connector
von Ashys
4
Downloads
4
Likes
0
Makes
A wall face plate that allows you to connect an air con tube (OD around 130mm) to a PVC pipe (ID around 150mm).
This plate has a hole for a small silicone tube (10mm OD) to go through the same pipe as the exhaust to drain the excess water.
This was specifically made for my Inventor Chilly 9000BTU Air con so I didn't need to keep emptying a bottle on hot days.
Make sure your wall tube is lower than the water outlet's high point or else it won't drain properly.
Printed in regular PLA and its held up fine for nearly a year with no sign of deforming from the heat.
A print area of at least 200mmx200mm is required to print this
Not my best model as it requires a fair amount of support to print, however it's been sat on my PC for a year and thought I'd put it out there if anyone needs it.
This plate has a hole for a small silicone tube (10mm OD) to go through the same pipe as the exhaust to drain the excess water.
This was specifically made for my Inventor Chilly 9000BTU Air con so I didn't need to keep emptying a bottle on hot days.
Make sure your wall tube is lower than the water outlet's high point or else it won't drain properly.
Printed in regular PLA and its held up fine for nearly a year with no sign of deforming from the heat.
A print area of at least 200mmx200mm is required to print this
Not my best model as it requires a fair amount of support to print, however it's been sat on my PC for a year and thought I'd put it out there if anyone needs it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
