Airsoft CrossBow Adapter

This was made for a ollies archery dart set. This will adapt the crossbow from darts to airsoft bbs. I do have a support free version but the supports for this are only needed for the cylinder so in your slicer make sure supports are off for the gun portion.

Print the part unscrew the screw in front glue the cylinder to the gun part it slots in slide the parts on the crossbow put the screw on over the "fork" after that secure using the hole in the gun using a zip tie to keep it in place as shown in picture. Be sure to remove the safety its the screw on the bottom of the crossbow take the spring out but the screw and black piece back. If you ever wanna use the darts again just reverse steps.

" I went through a few iterations so if this has any issues let me know but this should be the latest one I have used and tested to be fine."

A easy hack if you need to try it I never did but you can change the horizontal expansion settings in cura to shrink or expand the outer wall might make bb