Thingiverse
Airsoft foregrip
von 97bradley
2.6k
Downloads
2.1k
Likes
8
Makes
Its back, with a thingiverse friendly name!! Apparently "Gun Foregrip" doesnt work for them and they pulled it..... This will slide onto a picatinny rail and screw on tight. Once I have printed and tested I will add pictures. Also, it reaches 115 mm so make sure your firmware allows that.
The pictures are of a previous smaller version to just show the screw
UPDATE
The test print of this worked perfectly. The screw fits and the guides fit right onto a rail. I am going to make a few final revisions to the height of the core and the top pin and then it should be fully working.
UPDATE
Alright there it is: what is hopefully the final revision. It should be fully functional. If you already printed the full sized handle with the bad screw then you can just print the new screw and it should fit the handle
FINAL UPDATE
ok so i have this thing printing and it works really well. THe one issue is the screw doesnt go in perfectly and is a real pain the first time you screw it in. I
The pictures are of a previous smaller version to just show the screw
UPDATE
The test print of this worked perfectly. The screw fits and the guides fit right onto a rail. I am going to make a few final revisions to the height of the core and the top pin and then it should be fully working.
UPDATE
Alright there it is: what is hopefully the final revision. It should be fully functional. If you already printed the full sized handle with the bad screw then you can just print the new screw and it should fit the handle
FINAL UPDATE
ok so i have this thing printing and it works really well. THe one issue is the screw doesnt go in perfectly and is a real pain the first time you screw it in. I
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
