Airsoft or Nerf spring target

This is a spring loaded target stand that uses a metal can lid to take the hits. It makes a nice ring and visibly bounces when hit, so no more pretending you actually made the shot... It comes in two versions, the straight and the curved.

The straight one is mounted to a flat surface and has the target above it, this version is more prone to getting shot though. The curved version mounts to a wall or fence by hooking onto a nail, and you can see that the entire mechanism is protected by the target.

It takes about two hours to print and should be done without supports. Once finished, carefully use an exacto knife to cut a slit in the clip so that a metal can lid can be slid in.

Let me know if you need me to make any adjustments to the designs or if you have any ideas on what I should design next. I have a few other unique target designs that are all made take very little time to print in case you want to make a little shooting range.