Airsoft Suppressor for SRS Silverback

A friend requested a suppressor large enough to accommodate a cloak foam kit of 37mm diameter. The design requires the first ~4" [10cm] of your outer barrel to be free of obstructions - so it won't fit if you have a long handguard. The suppressor extends over the outer barrel for support and should be a snug fit. It's designed to have an interference fit with the 14mm thread so it should self-thread on just enough to hold it in place.

Both versions require minimal supports on the extensions, but otherwise is designed to be modular with a minimum foam length of 6" [15.2cm] with 3" [7.6cm] extensions.

V1 is on the large and bulky side clocking in at a 6cm outside diameter. I overdesigned just slightly...

V2.1 is significantly slimmed down and should be about 45% less mass than the original.