Thingiverse
Airsoft Target Trap (Plastic BBs only)
1k
Download
828
Likes
3
Makes
This is my take on an airsoft target holder with built in pellet trap, catering for 140mm square targets. It includes an immediate trap which funnels the pellets into a separate catcher compartment for containment and easy disposal. It can be used free-standing or by hanging.
Tested with 6mm 0.20g plastic BBs at approx 300fps ONLY
Print the main body on its back (no supports) with 0.32mm layer height and 4x perimeters. This will reduce printing time and increase strength and layer adhesion. Print the target clips and catcher door with 0.2mm layer height for added fitting quality.
The trap walls are 3.2mm thick and will print solid. It stands up to my airsoft pistol, which is a standard 320fps model shooting 6mm 0.20g plastic BBs. Your mileage may vary, but I doubt it will stand up steel BBs, lead pellets or anything powerful.
Glue in three target clips with Superglue.
Fit the catcher compartment door with a length of filament as a hinge. You may find the holes for the
Tested with 6mm 0.20g plastic BBs at approx 300fps ONLY
Print the main body on its back (no supports) with 0.32mm layer height and 4x perimeters. This will reduce printing time and increase strength and layer adhesion. Print the target clips and catcher door with 0.2mm layer height for added fitting quality.
The trap walls are 3.2mm thick and will print solid. It stands up to my airsoft pistol, which is a standard 320fps model shooting 6mm 0.20g plastic BBs. Your mileage may vary, but I doubt it will stand up steel BBs, lead pellets or anything powerful.
Glue in three target clips with Superglue.
Fit the catcher compartment door with a length of filament as a hinge. You may find the holes for the
colinp_hughes pubblica anche su
16 modelli aggiuntivi su altre 2 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
