Airtech 3000 Mods

Various mods to work with Airtech 3000. Mods include: barrel spacer, turret, rotation stop, hornet pump conversion cylinder, and hornet pump front block. Print on a smooth plate for best seal with air tank. SUNLU Blue PETG seems to match the blue colouring on the blaster very well. You will need to take out the original metal rod from the rear of the orange turret. I used boiling water and some pliers and it came off within a few tries. When putting the bar into the rear of the printed turret, make sure that the small hole near the top of the metal bar is aligned with one of the big holes in the printed turret. I found that putting a small nail through the hole and looking top down is the best way to get them aligned. Epoxy or superglue it in. Depending on the alignment, it is possible that the rotation stop doesn't work for you. You might have to fabricate this depening on your exact blaster. Hardware used:6 13mmx15mm Polycarbonate Tubing (12inch) https://www.amazon.ca/dp/B0CTGWGR