Slicer Discord
AirZooka! – 3D-Druckmodell von Thingiverse Thingiverse

AirZooka!

von mindcode
214 Downloads
167 Likes
4 Makes
Zum Modell
AirZooka!

Shoot rings of air up to 30 feet and blow out candles or just annoy people with harmless air rings. Also possible: Using smoke to see the air rings. You may check on Youtube for "AirZooka". This one here is the same prinicple, but smaller.

- This is Version 1

You are going to need a ballon which needs to be cut in half.
After this itn needs to be pulled over the airzooka's bigger end
and be fixed with the ring. Look at the pictures for further reference!

Print it with the small end facing down and use supports for the handle.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen