AK47 working replica V2

V2. Hasn't been tested, but seems to check out in tinkercad. Will make instructions once I print all parts.

***May 2026 update***

- Added 2-piece receiver and made the tang that holds the stock into a separate piece that needs to be glued to the receiver. Should be easier to print / stronger.
- Made the recoil spring rod "button" into a separate piece, needs a bolt/screw and a spring. This way only the button needs to be pressed to remove dust cover, instead of moving the whole recoil spring rod to get the cover off.
- Made bolt carrier into two pieces for easier printing, use glue to assemble.
- Remade gas piston.
- Added sear.
- Edited trigger and disconnector.
- Edited safety lever.

Pin 1 is for everything that attaches to the barrel, need to print 7, can be trimmed to length if you want. Pin 2 is for the trigger guard, needs 5
Scale the pins if they are too lose in the holes, pins are 3.8mm while their holes are 4mm.
4x M4 bolts are needed to attach grip and stock to the receiv