Akira Hueforge

MembershipIf you want to sell prints of this model, as well as all of my models Subscribe for a commercial License You cannot adjust the z scaling on any hueforge. This will mess with the coloring done and your hueforge will not come out as intended. You can however change the x and y to scale the picture. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmSwap Instructions:Start with BlackAt layer #8 (0.72mm) swap to RedAt layer #15 (1.28mm) swap to YellowAt layer #18 (1.52mm) swap to White for the rest.