AKRO-MILS SMD storage

Trays with sliding lids to securely hold SMD components (50 x 0805, 20 x 1206 in each compartment).

1 small AKRO-MILS drawer can hold 2 long (E12 x 6) and 4 short (E6 x 6) trays.
Snug fitting lid: Components will not spill into other compartments even if upside down.
Use 2 E12x6 to store E24 resistors.

Use paper labels on the lid for identification and tabs on the labels to help pull them out of the drawer. They are a snug fit.
Depending on the print quality may need to clean the grooves for the lid or sand the lid down.

Note: The lid should sit flat on the tray, sand sides if needed. Excessive snugness will cause the lid to buckle and the components will spill into other compartments if turned upside down.