AlbaBird FPV Camera Pan mount

Wanted a simple Pan mount for my Albabird. I did not need a Pan and Tilt mount so I designed a basic Pan only mount. With the gears used in the comments I can get about 130 degrees in either direction. I used a small 5 gram servo (the cutout is for my servo you may need to open it up for yours) Gears I found on Amazon (link below) I used a servo horn that came with the servo as well as the servo horn screw.
Assembly is simple.
I used Goop to glue things together.
Adhere the servo from the bottom of the platform (tabs are out of site)
Print out the filler plug and glue it up inside of the deepest area of the larger gear.
Glue and center the servo horn of choice to the filler plug
If you use my Camera holder glue it to the smaller gear and center it up and let dry.
Slide the smaller gear over the post on the platform.
The hole in the post is 1.5mm in diameter. Depending on the screw of choice you may need to open it up slightly.
Use a washer (about 7 to 10mm in diameter) and pop