Alfa Awus036h mount

it's two parts the holder and the clamp the holder can be print with support internally on the flat surface with 40% infill

the clamp base need to be 100% infill print also on the flat surface without support
the top clamp will need support under the axe holes part and print it diagonally as in the photo

a small square grove on the back of the holder this is to glue the clamp in it the clip base has square in the lower that fit the one with the grove


all parts need 3-4 top/bottom layers and 4 perimeters

you need
- torsion or double torsion spring
- nail for the spring axe